Loading... Please wait...

Ethernet LAN Module for Arduino / microcontrollers with SPI (ENC26J80)

Hover over image to zoom

  • Image 1
  • ENC28J60 Connections to Arduino
1.00 Ounces
Calculated at checkout
Gift Wrapping:
Options available

Quantity Discount Per Item (contact us for larger quantities)

 Product Description

Ethernet  LAN Module for Arduino and other controllers with SPI (ENC26J80)

This low-cost ethernet solution for Arduino and many other microcontrollers is Arduino ENC28J60 library compatible and easy to use. Arduino pin connection is in a separate photo.


  • Based on ENC28J60-I/SO
  • High quality PCB
  • Clock based on 25Mhz crystal
  • Standard RJ45 jack with yellow and green LEDs
  • 3.3 V power supply
  • Size: 5.9cm x 3.5cm - 2.32inch x 1.38inch


You can find the EtherCard library here. The EtherBright library is here. The newest library and perhaps the easiest to use given its method compatibility with the standard ethernet library, is uipethernet and can be found here.




 Product Documents

// A simple web server that always just says "Hello World"

#include "etherShield.h"

#include "ETHER_28J60.h"

static uint8_t mac[6] = {0x54, 0x55, 0x58, 0x10, 0x00, 0x24};   // this just needs to be unique for your network, 

                                                                // so unless you have more than one of these boards

                                                                // connected, you should be fine with this value.


static uint8_t ip[4] = {192, 168, 1, 15};                       // the IP address for your board. Check your home hub

                                                                // to find an IP address not in use and pick that

                                                                // this or are likely formats for an address

                                                                // that will work.

static uint16_t port = 80;                                      // Use port 80 - the standard for HTTP

ETHER_28J60 ethernet;

void setup()


  ethernet.setup(mac, ip, port);


void loop()


  if (ethernet.serviceRequest())



Hello World

"); ethernet.respond(); } delay(100); }

 Find Similar Products by Category

You Recently Viewed...


What's News


Copyright 2019 oddWires. All Rights Reserved.
 Sitemap | oddWires

Click the button below to add the Ethernet LAN Module for Arduino / microcontrollers with SPI (ENC26J80) to your wish list.